How to assemble a battery

How to Install Battery

There are also hints in installed batteries

This installation is wrong.

Install as follows correctly. When installing, try to install from the negative pole. The installation from the positive pole may not be installed, and it may also damage the battery warehouse.

The battery installation of the water heater may be a bit confusing because he is not so detailed and not so obvious so it needs to be carefully observed.

After the positive and negative poles are determined, the battery can be inserted.

Battery case, brush headset, high-precision pole weighing instrument, pole plate, partition board, lead part, pole group box, pole group welding mold, pack box, bridge welding clamp, pole column, sealant, gel, upper cover, terminal, chemical machine.

Assembly Battery Steps

Check all raw materials for adequacy and damage.

2 check the plate, the plate brown black is the positive plate blue Brown is the negative plate

3 Brush off the oxide above the ear with a brush headset, etc..

The weight of the 4-pole plate is weighed, and the difference between the weight of the cluster is best not to exceed 3 grams. A high-precision pole weighing instrument is used here.

5 packings, use the partition to separate the positive and negative plates. It is mainly to wrap the positive plate to prevent the positive and negative plates from being scrapped. Then pack it in a box.

6 Welding clusters will be used to cluster welding dies.

7 Load welded poles into battery case

8 bridge welding, use to bridge welding pliers.

9 Welded on pole column, seal with sealant.

10 After adding the electrolyte from the filling mouth, seal the filling mouth, add the terminal to the pole, and then add the gel.

Such a large battery has already been assembled, leaving the last step to be used as a mechanical achievement. Such a battery for an electric car is ready.

Points to Note when Battery Assembly

1 It is important to pay attention to the weight of the polar plate when bearing. The difference between the upper and lower weights should not exceed 3 grams.

Watch out for extra parts on the bottom of the 2 pack.

3 When adding chromatin, prevent chromatin from entering the cluster. Add sealing ring and then add chromatin.

The page contains the contents of the machine translation.