Jan 18, 2019 Pageview:1110
1, Dry battery almost no maintenance, worry and effort! If water and electricity bottle maintenance is good the service life is longer than the dry battery. If the maintenance is not good, the service life is shorter than the dry battery! The key is to see how the user maintenance.
2. The water bottle is most afraid of the lack of liquid. Regularly observe the liquid level of the battery. When the liquid is lacking, add distilled water or electrolyte in time (depending on the battery power, add electrolyte when the battery is obviously insufficient, and charge it in time) to maintain the battery. At the same time, apply a little grease (butter) on both ends of the battery + and - electrodes to prevent corrosion at both ends of the electrode and prolong the battery life!
3. The overload capacity of water and electricity bottles is stronger than that of dry electricity; if it encounters a circuit failure. Dry electricity is more likely to die.
4, battery maintenance is very important, regular inspection.
It is found that the lack of liquid should be replenished in time; the low battery should be charged in time, and it is forbidden to continue to use it at this time.
The instantaneous current during electric starting can be as high as tens of amps! The impact of high currents is fatal to poorly performing batteries.
Pay special attention to the fact that even if there is a mechanical failure in the vehicle starting mechanism, even if the power is sufficient, it should be stopped immediately. The locked current of the starting motor in the case of the mechanical device is 3~7 times of the normal working current. I have seen a new battery that is forced to start for three seconds when the machine is stuck.
1. The inside of the battery is connected by wall welding, and the current discharge performance is good.
2. The battery cover is made of PP material, and the cover is heat-sealed to avoid leakage when the battery is used.
3. The grid alloy adopts multi-corrosion resistant alloy, and the positive grid is pressure cast to solve the grid corrosion short circuit.
4. Adopt advanced electrode plate curing and chemical conversion process to improve the bonding force between active material and grid and extend battery life.
5, the positive plate of the battery is tubular, the negative plate is paste-type, has a long service life, deep charge and discharge performance and other significant advantages
6. The use of polyester fiber discharge pipe and PVC separator can effectively solve the short circuit problem caused by pipe rupture and lead dendrites during use, and prolong the service life of the battery.
1. It is recommended that you use maintenance-free. If you use it frequently, it is recommended that you use a liquid water bottle.
2, must use water batteries, because you are using a brush series excitation motor power consumption, it is best to use 120AH water battery, with other batteries not resistant.
3, electric vehicle battery is the key, the general endurance ability of the market is not much, recently Xupai produced a doctor battery, very good, is the only combination of long life and long-life in the market.
4, the load is relatively large, to have a large capacity, the water battery generally has 120AH, the general rural area is more electric five-wheeled electric tricycle. The average dry battery is only a few dozen AH, not enough for you.
5, with 12v maintenance-free battery can be. 1 ampere hour is a special term for batteries. Indicates the energy required to discharge with 1 amp of current for 1 hour.
2100 ampere-hour 120 ampere-hour refers to the rated capacity of the battery. Not entirely proportional to the size of the volume, of course, the larger the rated capacity, the larger the volume.
3 Automobile belongs to the starting battery. which requires a large amount of current to be discharged in a short time. According to the design requirements, the battery with 100 amps of 100 amps should discharge more than 180 seconds. The internal structure of the battery is more and more thin. They are all slice type; the battery traction type battery of the electric tricycle is required to be uniformly discharged for a long time and is not suitable for large current discharge. The internal structure of the battery is small and thick, and the positive plate is tubular (also has a chip type).
4 It is not acceptable to use the battery of the electric tricycle to start the vehicle. The car battery is used as the traction battery on the electric tricycle. It can be used in a short time, and the long-term use will affect the life.
The dry battery can be used until it cannot be used, no need to re-add the electrolyte, and the volume is smaller than the storage capacity of the water battery, and it is lighter than the water battery. Generally, the lithium-ion battery is the main one (the mobile phone battery is). If the water battery is used, the electrolyte will be reduced for a period of time, and the electrolyte can be returned to normal. The disadvantage is that it is bulky and relatively bulky. Due to the use of gas, hydrogen (oxygen and oxygen) is likely to cause an increase in the internal pressure of the battery, which may leak out the electrolyte and corrode external parts. But dry batteries cost a little more, and water batteries are cheaper. According to the advantages and disadvantages of a specific, to analyze and choose where to use.
The page contains the contents of the machine translation.
Leave a message
We’ll get back to you soon