22 Years' Battery Customization

What is the difference between lithium 5 battery and nickel metal hydride battery?

Aug 30, 2019   Pageview:607

What is the no. 5 rechargeable lithium battery?

No.5 rechargeable lithium battery is another name for cylindrical 14500 lithium battery, size 14*50mm.

Purpose of no.5 rechargeable lithium battery: See most people put it to use on the camera, because the size of the rechargeable lithium battery with the average of 5 5 battery, so can be used to replace, but it is worth noting that the 5th rechargeable lithium battery monomer voltage is 3.7 V, and the normal battery voltage of 1.5 V, 5 so 5 rechargeable lithium batteries for the camera on just one day, when finish again tie-in stanza electricity 5 carbon batteries or 5 alkaline batteries (the batteries are negative short circuit, also is the equivalent of a wire, actually provide electricity is only the section V lithium battery), through practical test shows that A no. 5 rechargeable lithium battery lasts twice as long as an ordinary no. 5 battery.

What's the difference between a lithium battery and a nickel metal hydride battery

What is a rechargeable nickel-metal hydride no. 5 battery?

Nickel-cadmium rechargeable batteries are charged at 1.6 times the voltage and are usually charged 300 to 800 times. After 500 charges and discharges, the capacitance will decrease to only about 80%. The disadvantage of nickel-cadmium batteries is that during charging and discharging, the cathode will grow needle-like crystals of cadmium, which sometimes penetrate the separator and cause the internal dendritic crystal-like short circuit.

Nickel-metal hydride rechargeable batteries are designed primarily to replace nickel-cadmium batteries. Nickel-metal hydride batteries use nickel oxide as the anode, and metal alloys absorbing hydrogen as the cathode, potassium hydroxide alkaline aqueous solution as the electrolyte. Nickel-metal hydride batteries have a higher energy density than nickel-metal hydride batteries. The capacity of nickel-metal hydride batteries of the same volume can reach about twice that of nickel-metal hydride batteries. At the same time it does not contain harmful metals, more environmental protection, at the same time nickel hydrogen battery basically eliminated the "memory effect". It is highly charged and can be fully charged up to 90 per cent in two hours. However, it is not resistant to overcharge and overdischarge, so the charger of this kind of battery must be able to automatically cut off power, otherwise it is easy to cause battery damage.

What's the difference between a lithium battery and a nickel metal hydride battery?

5 rechargeable batteries is lithium battery is good or nickel hydrogen battery what is the difference

1. The difference between nimh battery and lithium battery -- volume

Rechargeable lithium battery is widely used in many new mobile devices due to its advantages such as small size (relatively), light weight, low self-discharge rate and no memory effect compared with ordinary nickel-cadmium/nickel-metal hydride battery. The batteries of our ordinary mobile phones, laptops, pdas and other mobile devices have gradually been replaced by lithium batteries. Nickel-metal hydride battery memory effect is not very obvious, there is a point, to use urgently, not necessarily after the release of light charge, usually use is best after the release of light and then enough.

2. The difference between ni-mh battery and lithium battery -- power

Lithium battery is larger than the energy, the battery is small; The voltage of a single lithium battery is three times that of nickel metal hydride battery. No memory effect can be used on demand. But also cannot be used charge, such charge discharge number is overmuch; affect the life of the battery. Lithium battery is not suitable for long-term storage; a long time will permanently lose part of the capacity. It is best to charge 40 percent, put in the refrigerator freezer preservation.

3. The difference between ni-mh battery and lithium battery -- charging method

The charging requirements for lithium batteries are different from nickel-cadmium/nickel-hydride batteries. The voltage of a single rechargeable lithium battery is 3.6v (some batteries may be labeled as 3.7v). With the full charge, the voltage of the lithium battery will slowly increase, which is also a sign to judge whether the lithium battery is full. Generally, the manufacturer recommends the termination charging voltage of 4.2v (in the case of a single lithium battery). Voltage and current limiting method is generally adopted for charging lithium batteries. If a friend wants to charge lithium batteries independently, it is necessary to note that its charging method is different from the constant current charging method adopted by nickel-cadmium/nickel-hydride batteries, and the charger of ordinary nickel-cadmium/nickel-hydride batteries cannot be used.

Conclusion

Nickel-metal hydride battery belongs to the strict control product, will be less and less, until the elimination. Lithium battery is a new product, belongs to new energy products.

The page contains the contents of the machine translation.

*
*
*

Leave a message

Contact Us
Your name(optional)

* Please enter your name
* Email address

Email is required. This email is not valid
* How can we help you?

Massage is required.
Contact Us

We’ll get back to you soon

Done