How to add distilled water when motorcycle battery is out of power

In winter, many motorcycle batteries are broken. Water charged battery is not durable after a long time (mine was 3 months without successful repair). Poured over the battery water, and add water into the battery again for several times(had better use warm water). Then add the equipped water into battery until the charger is full, the battery may be back to work (this method is learned in a cart line) But it is only useful for water battery. I don't know the method for dry battery.

You first check whether the battery is short of liquid, for lack of liquid battery, add supplementary liquid to liquid level line between up and down, and then you type fire, can see, if you can't start, use multimeter to measure voltage, if the voltage is above 10.50 V, can directly use the charger is full of electricity can, after a full charge measure the proportion of the electrolyte, if the voltage is below 10.50 V, it must be fixed with repair instrument of high resistance increase the voltage to 10.50 V, then it is ok to charge, after a full charge, it is best to repair the instrument repair, removal of sulfide, can use.

Battery repair plan reduce the battery capacity, electric distance shortened, even if the battery "necrosis", you don't try so hard, as we offer the solution, using our products: battery life extension repair kits - easy/easy to king treasure (hereinafter referred to as the prosthesis), diy, simple operation, you can get the unexpected surprise! Battery is composed of more than 2 pieces of monomer battery series (such as 36 v battery is composed of three of the 12 v battery series, 48 v battery is composed of 4 pieces of the 12 v battery series, etc.), the reason for this reduction in battery capacity is very complicated, but in the aggregate, mainly: 1, the battery plate vulcanized by crystallization, serious sulfide corrosion plates, the battery completely necrosis;2, battery plate because of the "charging" or "discharge" and softening, some even lead to plate lead powder falls off, perforation, shell deformation or electrolyte leakage, etc.;3, "filtration" battery (including maintenance-free battery) to produce electrolytic chemical reaction, serious "filtration" can make black electrolyte metamorphism or lump;4, electric start, acceleration, the heavy load of instantaneous current strain battery plate, the plate coating

Motorcycle time grew, battery in general are serious feed.

You first check whether the battery is short of liquid, for lack of liquid battery, add supplementary liquid to liquid level line between up and down, and then you type fire, can see, if you can't start, use multimeter to measure voltage, if the voltage is above 10.50 V, can directly use the charger is full of electricity can, after a full charge measure the proportion of the electrolyte, if the voltage is below 10.50 V, it must be fixed with repair instrument of high resistance increase the voltage to 10.50 V, then it is ok to charge, after a full charge, it is best to repair the instrument repair, removal of sulfide, can use. The first step, the motorcycle battery removed from the car. At this time to pay attention to is the cathode don't confused, remember the location. Also, on the motorcycle often have the elastic battery. With a phillips screwdriver battery

How to add distilled water motorcycle battery without electricity

The second step, look at the battery liquid, is below the minimum line, if it is, to add water, sometimes, because never add water, battery or even a little water all have no, the battery doesn't fire of course!

How to add distilled water motorcycle battery without electricity

The third step, the top stripes off of the battery, may be a bit tight, don't worry, exert oneself to do STH.

How to add distilled water motorcycle battery without electricity

With a syringe barrel drain distilled water or pure water, six hole injection respectively. Pay attention to the observation water level when water injection, not above the water line.

How to add distilled water motorcycle battery without electricity

Finally, six holes after water is added in place, the electric bottle back. Lighter can charge it with electricity.

First check whether the charger is in good condition, can find a lamp test (a multimeter so much the better).Two output test whether there is electricity, if in good (bad, to find a good one), recharging the battery (the positive to the positive, negative on cathode) 1 hours, to detect the battery voltage, if the voltage is too low, the preliminary judgment, the battery has a problem.

Open the battery in the middle of the plate, there are six to eight small risk, get off, see if the electrolyte inside overflow water absorbing sponge (if translucent when the battery shell, can put the lamp on the back of the battery light, view).

Buy battery supplements (generally 3% of dilute sulphuric acid, generally 2-3 yuan a bottle, a battery using enough. From the battery over with a syringe in the middle of the hole injection, until the overflow water absorbing sponge and a half centimeters. Added on a regular basis, which is beneficial to extend the life of the battery.

12 hours after completion of rehydration, recharging the battery, charger voltage 15 v, general electric charger can fish.(if the battery have no electricity, can use high electric voltage (over 15 v, such as 20 v, then good is 1-2 seconds after the cathode, disconnect, so 3-5 times) to activate the battery charge with 15 v)

Generally after the repair, basic can make use of the battery, the battery life when 2-3 years (often use life), put for a long time, really not easy to bad.

The page contains the contents of the machine translation.