Can overcharge lithium battery restore charging capacity?

How do you put the lithium battery restore charge capacity?

The battery discharge points two cases, one is single cell voltage is zero, every piece of batteries voltage drop to charger is a detectable range.

Monolithic batteries drops to zero, battery is completely broken, only when all the batteries in the case of about 3 v, can be saved. You need to prepare a and imitation board at this moment.

After the battery, connect the charger, detect voltage. Show the battery discharge. In order to save the battery back, we need to prepare a normal battery.

Shows the battery voltage is normal, put a battery back depends on it!

First put into both battery and charger plate, connect the charger, the charging current adjusted to 0.3 A. Note that want to put the battery back, must want to small current charging. When the battery charger will have prompt, remember to put the battery pull down!

Teach everyone to use below again and on-line save battery!

First of all make an on-line, according to some of your battery, with the right balance. Attention line order, don't make a mistake.

The battery discharge, and a piece of batteries testing.

To connect the two pieces of battery and wire first, and then plug in the charger. When connecting two pieces of battery, high voltage of the battery has low voltage to charge again. Note here in Settings when charging current is set to 0.3 A.

The page contains the contents of the machine translation.