How to activate the lithium battery

At present, mobile phone has become the most frequently used among people's Daily life for electronic products. The function of mobile phone people using is not just limited to the phone calls, send and receive text messages, but tend to surf the Internet, chat with friends, or watch video, read news and so on. Mobile phone is used more and more frequently. Its battery consumption is becoming faster and faster. A lot of mobile phones in R&D when considering the durability of the battery, we usually consider to let it hibernate, but how to activate it after that?

Tools/raw material

Mobile phone is not charging battery piece, full charge a battery

Two wire conductor

Mobile phone a, same model charger a, a power outlet

Methods/procedures

1, using two wires to A battery of the positive link to B battery positive electrode,

2, put the negative poles of A battery cathode link to B cells,

3, maintain a minute, so operation is over. Put a battery into the mobile phone, with the charger link to mobile phone, we will see the mobile phone charging status.

Matters needing attention

Be careful not to direct contact with the battery contact wire by hand

Be careful not to put across the make a mistake

Mobile phone batteries for a long time not to use to enter sleep mode.

Millet mobile phone battery automatic dormancy (not filling into electricity) processing method of the solution:

1, the use of low voltage 30 minutes to activate the battery charger, can use computer USB charging and charging treasure.

2, use the original link power charging line, don't use a mobile phone charging process.

3, standby recharged, rushed out please unplug the power supply immediately.

Looks like millet mobile phone in order to protect the battery, cell phone while it is used to automatically shut down every time, will charge it into electricity, into the automatic dormancy, characterized by light has been fast frequency flash a red light or the light is not bright. Millet customer service after normal explanation to plug into the power supply and so on 10 minutes can be normal charging. But this is often not the case, sometimes didn't charge it into electricity.

Sometimes there is an emergency need to charge their phone at once, the following will give a solution:

1, will plug the cable into millet mobile phone, at this time for the light is not normal reaction or flash. At this time, open the back cover to take out the battery.

2, if the screen displays for the boot interface, the charge is successful, can be normal charging, the battery pack back again, slow flash charging indicator light is normal. If not, is to take out the battery, normal for a successful, usually not more than three times can be successful

3, After charging successfully, the charging interface becomes normal. It is suggested that even if there is an emergency, don't start up the machine unless the electricity is above 4%.

The page contains the contents of the machine translation.